Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Exec Mode Show Commands (D-G)
▀ show diameter route table
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
show diameter route table
This command displays the Diameter routing table.
Product
All
Privilege
Security Administrator, Administrator, Operator, Inspector
Syntax
Displays the route table information in wide-format.
Displays the Diameter routing table for the specified endpoint.
must be the name of a Diameter endpoint, and must be a string of 1 through 63 characters
in length.
Specifies that output of this command is to be piped (sent) to the command specified. A command to send the
output to must be specified.
For details on the usage of
output to must be specified.
For details on the usage of
and
, refer to the Regulating a Command’s Output section of the
Command Line Interface Overview chapter in the Command Line Interface Reference.
Usage
Use this command to view the status of Diameter client endpoints.
If you are in the local context, then the route information used by Diameter endpoints in all chassis contexts
will be used in the display.
The route table displays all static and dynamic routes. Refer to the route-entry CLI command in Diameter
Endpoint Configuration Mode.
Default value: N/A
If you are in the local context, then the route information used by Diameter endpoints in all chassis contexts
will be used in the display.
The route table displays all static and dynamic routes. Refer to the route-entry CLI command in Diameter
Endpoint Configuration Mode.
Default value: N/A
Example
The following command displays status of the Diameter client endpoint named
The following command displays status of the Diameter client endpoint named
.