Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Global Configuration Mode Commands
▀ threshold nat-port-chunks-usage
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
threshold nat-port-chunks-usage
This command configures the NAT port chunk utilization threshold settings.
Important:
This command is only available in Release 8.3 and later releases.
Product
NAT
Privilege
Security Administrator, Administrator
Syntax
Configures the default settings.
Default: 0
Specifies the high nat-port-chunks-usage threshold that must be met or exceeded within the polling interval to
generate an alert or alarm.
Specifies the high nat-port-chunks-usage threshold that must be met or exceeded within the polling interval to
generate an alert or alarm.
must be an integer from 0 through 100. A value of 0 disables the threshold.
Default: 0
Specifies the low nat-port-chunks-usage threshold that must be met within the polling interval for a clear
alarm to be generated.
Specifies the low nat-port-chunks-usage threshold that must be met within the polling interval for a clear
alarm to be generated.
must be an integer from 0 through 100. A value of 0 disables the threshold. If not set, the
will be high and low threshold setting.
Usage
Use this command to configure the NAT port chunk utilization threshold settings.
Example
The following command sets the NAT port chunk utilization threshold settings to a high of 75 and a low of 15:
The following command sets the NAT port chunk utilization threshold settings to a high of 75 and a low of 15: