Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
HA Service Configuration Mode Commands
▀ threshold rereg-reply-error
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
threshold rereg-reply-error
Set an alarm or alert based on the number of re-registration reply errors per HA service.
Product
HA
Privilege
Security Administrator, Administrator
Syntax
Deletes the alert or alarm.
Default: 0
The high threshold number of re-registration reply errors that must be met or exceeded within the polling
interval to generate an alert or alarm. It can be configured to any integer value between 0 and 100000.
The high threshold number of re-registration reply errors that must be met or exceeded within the polling
interval to generate an alert or alarm. It can be configured to any integer value between 0 and 100000.
Default:0
The low threshold number of re-registration reply errors that must be met or exceeded within the polling
interval to clear an alert or alarm. It can be configured to any integer value between 0 and 100000.
The low threshold number of re-registration reply errors that must be met or exceeded within the polling
interval to clear an alert or alarm. It can be configured to any integer value between 0 and 100000.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to set an alert or an alarm when the number of re-registration reply errors is equal to or
greater than a specified number of calls per second.
Alerts or alarms are triggered for the number of re-registration reply errors on the following rules:
greater than a specified number of calls per second.
Alerts or alarms are triggered for the number of re-registration reply errors on the following rules:
Enter condition: Actual number of re-registration reply errors > High Threshold
Clear condition: Actual number of re-registration reply errors £ Low Threshold
Example
The following command configures a reregistration reply error threshold of 1000 and a low threshold of 500 for a
system using the Alarm thresholding model:
threshold rereg-reply-error 1000 clear 500
The following command configures a reregistration reply error threshold of 1000 and a low threshold of 500 for a
system using the Alarm thresholding model:
threshold rereg-reply-error 1000 clear 500