Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
IuPS Service Configuration Mode Commands
▀ plmn
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
plmn
Configures the PLMN (public land mobile network) related parameters for the IuPS service. This command is appicable
to releases 8.1 and higher.
to releases 8.1 and higher.
Product
SGSN
Privilege
Security Administrator, Administrator
Syntax
Removes the PLMN ID from the configuration.
Creates a PLMN configuration instance based on the PLMN ID (comprised of the MCC and MNC). In
accordance with TS 25.413, the SGSN supports up to 32 PLMN configurations for shared networks.
accordance with TS 25.413, the SGSN supports up to 32 PLMN configurations for shared networks.
Specifies the mobile country code (MCC) portion of the PLMN‘s identifier.
The PLMN MCC identifier and can be configured to any integer value between 100 and 999.
Specifies the mobile network code (MNC) portion of the PLMN‘s identifier.
The PLMN MNC identifier and can be configured to any 2-digit or 3-digit value between 00
and 999.
When network sharing is employed, this set of keywords is required to define the PLMN ID of the common
PLMN. The common PLMN is usually not the same as the local PLMN.
PLMN. The common PLMN is usually not the same as the local PLMN.
When network sharing is employed and more than two PLMNs are available, then use the
keyword to begin a list of all additional PLMNs.
Usage
Use this command to configure the PLMN associated with the SGSN. There can only be one PLMN
associated with an SGSN unless one of the following features is enabled and configured: network sharing or
multiple PLMN.
For network sharing, use of the
associated with an SGSN unless one of the following features is enabled and configured: network sharing or
multiple PLMN.
For network sharing, use of the
keywords make it possible to identify more than one
PLMN. Including the PLMN identified initially. None have precedence. They are all treated equally but they