Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
ACS Host Pool Configuration Mode Commands
▀ ip
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
ip
This command specifies an individual or a range of host IP address(es) to add to the host pool.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Removes the specified IP address(es) that were configured previously from this host pool.
Specifies an individual host IP address to add to this host pool.
is the IP address in dotted decimal notation for IPv4 and in colon notation for IPv6.
Specifies an individual host IP address with subnet mask bit to add to this host pool.
is the IP address in dotted decimal notation for IPv4, and in colon notation for
IPv6 with subnet mask bit. The
is a numeric value which is the number of bits in the subnet mask.
Specifies a range of host IP addresses to add to this host pool.
is the start IP address of the range in dotted decimal notation for IPv4 and in colon notation for
IPv6, and must be less than
.
is the end IP address of range in dotted decimal notation for IPv4 and in colon notation for IPv6,
and must be greater than
.
Usage
Use this command to add an individual or range of IP addresses to the host pool. Up to 10 sets of IP addresses
can be configured in each host pool.
can be configured in each host pool.
Example
The following command adds all IP addresses from
The following command adds all IP addresses from
through
in IPv4 notation to the host pool: