Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
OSPF VRF Configuration Mode Commands
▀ neighbor
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
neighbor
This command configures OSPF routers that interconnect to non-broadcast networks.
Product
PDSN, HA, GGSN
Privilege
Security Administrator, Administrator
Syntax
Disables
IP address.
The interface IP address of the OSPF neighbor. This must be an IP address entered in dotted-decimal
notation.
notation.
Default: 120
Set the number of seconds in the dead neighbor polling interval. This must be an integer from 1 through
65535
Set the number of seconds in the dead neighbor polling interval. This must be an integer from 1 through
65535
Default: 0
Set the 8-bit number that represents the router priority value of the non-broadcast neighbor associated with
the IP address specified. This must be an integer from 0 through 255. This keyword does not apply to point-
to-multipoint interfaces.
Set the 8-bit number that represents the router priority value of the non-broadcast neighbor associated with
the IP address specified. This must be an integer from 0 through 255. This keyword does not apply to point-
to-multipoint interfaces.
Usage
Use this command to configure OSPF routers that connect to non-broadcast networks.
Example
The following command specifies an OSPF router neighbor with the IP address of
The following command specifies an OSPF router neighbor with the IP address of
: