Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
SGSN Service Configuration Mode Commands
mobile-application-part ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
mobile-application-part
This command identifies an already defined MAP service (Mobile Application Part service) to associate with the SGSN
service. Although the MAP service does not need to be defined in the same context as the SGSN service, there is a one-
to-one relationship between a MAP service and an SGSN service.
service. Although the MAP service does not need to be defined in the same context as the SGSN service, there is a one-
to-one relationship between a MAP service and an SGSN service.
Product
SGSN
Privilege
Security Administrator, Administrator
Syntax
Remove the MAP service association from the SGSN service configuration.
Specifies the name of the MAP service to be associated with this SGSN service.
must be the name of a MAP service previously configured on the system.
Specifies the name of the context where the MAP service is configured. If the MAP service is not configured
in the current context, then the context where it is configured must be specified to enable the SGSN to reach
the MAP service.
If this keyword is not specified, the current context is used.
in the current context, then the context where it is configured must be specified to enable the SGSN to reach
the MAP service.
If this keyword is not specified, the current context is used.
Must be the name of the context where the specified MAP service is configured.
Usage
Use this command to identify the MAP service configuration to be used by the SGSN service configuration.
Also use this command to specify the context in which the MAP service configuration was created.
If the MAP service is not identified or if the correct context is not identified, then the SGSN service will not
START.
Also use this command to specify the context in which the MAP service configuration was created.
If the MAP service is not identified or if the correct context is not identified, then the SGSN service will not
START.
Example
The following command specifies a MAP service named map1 that is configured in the same context as the current
SGSN service:
The following command specifies a MAP service named map1 that is configured in the same context as the current
SGSN service: