Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
S-GW Service Configuration Mode Commands
▀ gtpu-error-ind
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
gtpu-error-ind
Configures the actions to be taken upon receiving a GTP-U error indication from an eNodeB or P-GW.
Product
S-GW
Privilege
Administrator
Syntax
Rests the command to the default action for the specified interface. For S1-U,
is the default action.
For S5-U,
is the default action.
Specifies the action to take when a GTP-U error indication is received from an eNodeB over the S1-U
interface.
interface.
: The S-GW clears the affected bearer (or PDN if error-ind is received on default bearer)
locally without informing peer.
: The S-GW moves the complete UE state to S1-Idle and starts
paging for this UE. If the custom1-behavior option is specified, the S-GW will guard the paging attempt with
a timer of 60 seconds. Within this time the bearer must have the eNodeB TEID refreshed by an MME.
Otherwise, the S-GW will clear the affected bearer with signaling. This is the default action for GTP-U error
indication messages received on the S1-U interface.
a timer of 60 seconds. Within this time the bearer must have the eNodeB TEID refreshed by an MME.
Otherwise, the S-GW will clear the affected bearer with signaling. This is the default action for GTP-U error
indication messages received on the S1-U interface.
Specifies the action to take when a GTP-U error indication is received from a P-GW over the S5-U interface.
: The S-GW clears the affected bearer (or PDN if error-ind is received on a default bearer)
locally without informing the peer. This is the default action for GTP-U error indication messages received
on the S5-U interface.
on the S5-U interface.
: The S-GW initiates control signalling towards the peer MME and P-GW. When signalling:
For a bearer deletion, the S-GW sends a Delete-Bearer-Command message to the P-GW and a Delete-
Bearer-Request (with EBI) message to the MME.
For PDN deletion, the S-GW sends a Delete-Session-Request message to the P-GW and a Delete-
Bearer-Request (with LBI) message to the MME.
The S-GW will not wait for Delete replies from the peer. The request will be sent only once and local
resources will be reset.
Usage
Use this command to specify the action to taken upon receiving a GTP-U error indication from either an
eNodeB across an S1-U interface or from a P-GW across an S5-U interface.
eNodeB across an S1-U interface or from a P-GW across an S5-U interface.