Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Subscriber Configuration Mode Commands
ppp ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
ppp
Configures the point-to-point protocol options for the current subscriber.
Product
PDSN, GGSN
Privilege
Security Administrator, Administrator
Syntax
Restores the default value for the option specified.
Resets the option specified to its default.
Default: Enabled
If the always-on feature is enabled for a session, this keyword enables the PDSN to send special 3GPP2 VSE
PPP packets to the Mobile Node with a max inactivity timer value. This configuration is applicable only for
PDSNsessions.
If the always-on feature is enabled for a session, this keyword enables the PDSN to send special 3GPP2 VSE
PPP packets to the Mobile Node with a max inactivity timer value. This configuration is applicable only for
PDSNsessions.
Default: None
This is used to configure a 6to4 tunnel. It controls the behavior of IPv6CP negotiation for Interface ID.
If enabled, PDSN will accept a valid interface-id proposed by the peer.
This is used to configure a 6to4 tunnel. It controls the behavior of IPv6CP negotiation for Interface ID.
If enabled, PDSN will accept a valid interface-id proposed by the peer.
Default: all protocols enabled.
Specifies the subscribers mode of data compression or the compression protocol to use.
Specifies the subscribers mode of data compression or the compression protocol to use.