Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Tunnel Interface Configuration Mode Commands
ip address ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
ip address
This command configures the IPv4 address for the specific tunnel interface.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Removes the configured IPv4 address bound to a tunnel interface.
Specifies a destination IP address or group of addresses that will use this route.
: Specifies a combined IP address subnet mask bits to indicate what IP addresses
to which the route applies.
must be specified using the form ‗IP Address/Mask
Bits‘ where the IP address is specified using the standard IPv4 dotted decimal notation and the mask bits are a
numeric value which is the number of bits in the subnet mask.
numeric value which is the number of bits in the subnet mask.
: Specifies an IP address and the networking (subnet) mask pair which is used to
identify the set of IP addresses to which the route applies.
must be specified using the
standard IPv4 dotted decimal notation.
must be specified using the standard IPv4 dotted decimal
notation as network mask for subnets.
The mask as specified by
The mask as specified by
or resulting from
is used to determine the
network for packet routing.
0‘s in the resulting mask indicate the corresponding bit in the IP address is not significant in determining the
network for packet routing.
1‘s in the resulting mask indicate the corresponding bit in the IP address is significant in determining the
network.
0‘s in the resulting mask indicate the corresponding bit in the IP address is not significant in determining the
network for packet routing.
1‘s in the resulting mask indicate the corresponding bit in the IP address is significant in determining the
network.
Usage
Use this command to bind the IPv4 address to a tunnel interface. This address does not affect the
encapsulation of packets going out on the tunnel interface.
encapsulation of packets going out on the tunnel interface.
Example
The following command will assign the
The following command will assign the
as IPv4 address to this tunnel interface: