Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
ACS Rulebase Configuration Mode Commands
ip reassembly-timeout ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
ip reassembly-timeout
This command configures how long to hold onto IP fragments for reassembly, while waiting for the complete packet to
arrive.
arrive.
Product
ACS
Privilege
Security Administrator, Administrator
Syntax
Configures the default IP Reassembly Timeout setting.
Default: 5000 milliseconds
Default: 5000 milliseconds
Specifies the timeout period to hold fragmented packets before reassembly.
is the duration, in milliseconds, and must be an integer from 100 through 30000.
Usage
Use this command to configure duration for timeout timer to hold IP fragmented packets before reassembly is
needed.
IP fragmented packet are retained, until either all fragmented packets have been received or the configured
timeout has expired for the oldest fragment. If all fragments have been received, a temporary complete packet
is reconstructed for analysis. Then all fragments are forwarded in order from first to last. If all fragments are
not received, the fragments will be forwarded without being passed through the protocol analyzers, except for
the IP analyzer.
needed.
IP fragmented packet are retained, until either all fragmented packets have been received or the configured
timeout has expired for the oldest fragment. If all fragments have been received, a temporary complete packet
is reconstructed for analysis. Then all fragments are forwarded in order from first to last. If all fragments are
not received, the fragments will be forwarded without being passed through the protocol analyzers, except for
the IP analyzer.
Example
The following command sets the timeout timer to
The following command sets the timeout timer to
milliseconds: