Cisco Cisco Packet Data Interworking Function (PDIF) Guida Alla Risoluzione Dei Problemi
Context Configuration Mode Commands
▀ diameter authentication failure-handling
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
: Specifies the result code, must be an integer from 1 through 65535.
: Specifies the upper limit of a range of result codes.
must
be greater than
.
: Specifies action to be taken
for failures:
: Continues the session
: First retries, if it fails then terminates the session
: Terminates the session
Usage
Use this command to configure error handling for Diameter EAP, EAP-termination , and authorization
requests. Specific actions (continue, retry-and-terminate, or terminate) can be associated with each possible
result-code. Ranges of result codes can be defined with the same action, or actions can be specific on a per-
result code basis.
requests. Specific actions (continue, retry-and-terminate, or terminate) can be associated with each possible
result-code. Ranges of result codes can be defined with the same action, or actions can be specific on a per-
result code basis.
Example
The following commands configure result codes 5001, 5002, 5004, and 5005 to use "action continue" and result code
5003 to use "action terminate‖:
The following commands configure result codes 5001, 5002, 5004, and 5005 to use "action continue" and result code
5003 to use "action terminate‖: