Cisco Cisco Packet Data Interworking Function (PDIF) Guida Alla Risoluzione Dei Problemi
ACS Rulebase Configuration Mode Commands
egcdr time-duration algorithm ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
must be an integer from 1 through 4294967295.
Usage
Use this command to set the various time charging algorithms/schemes for time usage in eG-CDR.
For example, packets arrive at times T1, T2, T3 and T4. Then the typical time usage might be computed to be
T4 – T1. However, if say there is an idle period between times T2 and T3, then system will compute the time
usage to be (T2 – T1) + (T4 – T3).
For example, packets arrive at times T1, T2, T3 and T4. Then the typical time usage might be computed to be
T4 – T1. However, if say there is an idle period between times T2 and T3, then system will compute the time
usage to be (T2 – T1) + (T4 – T3).
in above scenario calculates the time duration as (T2 – T1) + (T4 – T3) where
with
with
calculates the time duration as (T2-T1)+I + (T4 – T3)+I or (T4-T1).
Example
The following command sets consumed time duration to
The following command sets consumed time duration to
seconds: