Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Congestion Control
▀ Overview
▄ Cisco ASR 5000 Series Enhanced Feature Configuration Guide
OL-22983-01
Overview
This section provides an overview of the Congestion Control feature.
Congestion Control monitors the system for conditions that could potentially degrade performance when the system is
under heavy load. Typically, these conditions are temporary (for example, high CPU or memory utilization) and are
quickly resolved. However, continuous or large numbers of these conditions within a specific time interval may have an
impact the system‘s ability to service subscriber sessions. Congestion control helps identify such conditions and invokes
policies for addressing the situation.
under heavy load. Typically, these conditions are temporary (for example, high CPU or memory utilization) and are
quickly resolved. However, continuous or large numbers of these conditions within a specific time interval may have an
impact the system‘s ability to service subscriber sessions. Congestion control helps identify such conditions and invokes
policies for addressing the situation.
Congestion control operation is based on configuring the following:
Congestion Condition Thresholds: Thresholds dictate the conditions for which congestion control is enabled
and establishes limits for defining the state of the system (congested or clear). These thresholds function in a
way similar to operation thresholds that are configured for the system as described in the Thresholding
Configuration Guide. The primary difference is that when congestion thresholds are reached, a service
congestion policy and an SNMP trap, starCongestion, are generated.
way similar to operation thresholds that are configured for the system as described in the Thresholding
Configuration Guide. The primary difference is that when congestion thresholds are reached, a service
congestion policy and an SNMP trap, starCongestion, are generated.
A threshold tolerance dictates the percentage under the configured threshold that must be reached in order for
the condition to be cleared. An SNMP trap, starCongestionClear, is then triggered.
the condition to be cleared. An SNMP trap, starCongestionClear, is then triggered.
Port Utilization Thresholds: If you set a port utilization threshold, when the average utilization of all
ports in the system reaches the specified threshold, congestion control is enabled.
Port-specific Thresholds: If you set port-specific thresholds, when any individual port-specific
threshold is reached, congestion control is enabled system-wide.
Service Congestion Policies: Congestion policies are configurable for each service. These policies dictate how
services respond when the system detects that a congestion condition threshold has been crossed.
Important:
This section provides the minimum instruction set for configuring congestion control. Commands
that configure additional interface or port properties are provided in the Subscriber Configuration Mode chapters of the
Command Line Interface Reference.
Command Line Interface Reference.