Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
IP Security
Manual Crypto Map Configuration ▀
Cisco ASR 5000 Series Enhanced Feature Configuration Guide ▄
OL-22983-01
<
> is name by which the manual crypto map will be recognized by the system.
<
> is name of the pre-configured ACL. It is used for configurations not implementing the IPSec
Tunnel Failover feature and match the crypto map to a previously defined crypto ACL. This is an optional
parameter.
parameter.
<
> is name of the Crypto group configured in the same context. It is used for configurations using
the IPSec Tunnel Failover feature. This is an optional parameter.
For more information on parameters, refer to the Crypto Map Manual Configuration Mode Commands chapter in
the Command Line Interface Reference.
Verifying the Manual Crypto Map Configuration
These instructions are used to verify the manual crypto map configuration.
Step 1
Verify that your manual crypto map configurations by entering the following command in Exec Mode in specific
context:
context:
This command produces an output similar to that displayed below that displays the configuration of a crypto map named
test_map.
test_map.