Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi

MME Service Configuration Procedures

▀ MME Service Configuration

▄ Cisco ASR 5000 Series Mobility Management Entity Administration Guide

OL-22987-01

Configuring Session and Security Parameters for EPS bearer Contexts

Use the following example to configure the MME sessions and security parameters for EPS bearer context:

configure

context <

vpn_ctxt_name

mme-service <

mme_svc_name

apn <

apn_name

encryption-algorithm-lte priority <

value

> [ 128-eea0 | 128-eea1 | 128-eea2

]

integrity-algorithm-lte priority <

value

> [ 128-eia1 | 128-eia2 ]

max-bearers per-subscriber <

max_bearer

max-pdns per-subscriber <

max_pdn

end

Notes:

<max_bearer> is number of EPS bearers allowed for one subscriber.

<max_pdn> is number of PDNs allowed to access by one subscriber.

<apn_name> is name of the APN template to be used for subscriber when APN is not available from HSSS or

MS for specific subscriber.

Verifying MME Configuration

Step 1

Verify that your MME services were created and configured properly by entering the following command in Exec
Mode:

show mme-service name

mme_svc_name

The output of this command given below is a concise listing of MME service parameter settings as shown in the sample
output displayed. In this example, an MME service called mmesvc was configured and you can see some parameters
configured as default.

Service name : mmesvc

Context : ingress

Status : STARTED

Bind : Done