Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
MME Service Configuration Procedures
MME-HSS Service Configuration ▀
Cisco ASR 5000 Series Mobility Management Entity Administration Guide ▄
OL-22987-01
73
MME-HSS Service Configuration
This section provides instructions for configuring the MME-HSS service to provide S6a interface functionality on this
MME with HSS. Typically this service is configured in the same context as MME service.
MME with HSS. Typically this service is configured in the same context as MME service.
I
MPORTANT
:
This section provides the minimum instruction set for configuring MME-HSS service on
a system for S11 interface. Commands that configure additional MME-HSS service properties are provided in
MME-HSS Configuration Mode Commands chapter of Command Line Interface Reference.
MME-HSS Configuration Mode Commands chapter of Command Line Interface Reference.
These instructions assume that you have already configured the system level configuration as described in System
Administration Guide and MME service as described in section of this guide.
Administration Guide and MME service as described in section of this guide.
To configure the MME-HSS service properties on a system for an MME service:
Step 1
Configure Diameter endpoints and other parameters in the same context where MME-HSS is to be configured by
applying the example configuration in the Configuring Diameter AAA Functionality section provided in AAA Interface
Administration and Reference.
applying the example configuration in the Configuring Diameter AAA Functionality section provided in AAA Interface
Administration and Reference.
Step 2
Create the MME-HSS service by applying the example configuration in the Creating MME-HSS Service section.
Step 3
Associate the Diameter endpoint configured in step 1 with MME-HSS service configured at the step 2 by applying the
example configuration in the Associating Diameter Endpoint with MME-HSS Service section.
example configuration in the Associating Diameter Endpoint with MME-HSS Service section.
Step 4
Optional. Configure failure handling actions in event of request message failures with HSS on S6a by applying the
example configuration in the Configuring Failure Handling Actions on HSS section.
example configuration in the Configuring Failure Handling Actions on HSS section.
Step 5
Verify your MME-HSS configuration by following the steps in the Verifying MME-HSS Service Configuration section.
Step 6
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Creating MME-HSS Service
Use the following example to create the HSS-MME service to provide connectivity with HSS on S6a interface:
configure
context <
vpn_ctxt_name
>
mme-hss-service <
hss_svc_name
> -noconfirm
request timeout <
dur
>
end
Notes:
<vpn_ctxt_name> is name of the system context where you want to configure the MME-HSS service for S6a
interface with HSS. Typically this can be the same context where MME service is configured.
A maximum of 256 services (regardless of type) can be configured per system.
<dur> is the timeout duration in second for application message retransmission between MME and HSS.