Cisco Cisco Nexus 5010 Switch Guida Alla Risoluzione Dei Problemi
Nexus 5500 Scheduler Functionality with EEM
Scripts
Scripts
Document ID: 118894
Contributed by Austin Peacock, Cisco TAC Engineer.
Apr 10, 2015
Apr 10, 2015
Contents
Introduction
Prerequisites
Requirements
Components Used
Problem
Solution
Related Information
Prerequisites
Requirements
Components Used
Problem
Solution
Related Information
Introduction
This document describes a simple workaround that provides functionality similar to the Scheduler feature on
the Cisco Nexus 5500 Series switches that use Embedded Event Manager (EEM) scripts.
the Cisco Nexus 5500 Series switches that use Embedded Event Manager (EEM) scripts.
Prerequisites
Requirements
Cisco recommends that you have basic knowledge of these topics:
Cisco Nexus 5500 Series switches
•
EEM scripts
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco Nexus 5500 Series switches
•
Cisco Nexus Operating System (NXOS) Version 6.0(2)N2(1) or later
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Problem
The Cisco Nexus 5500 Series switches do not yet support the Scheduler feature in the 5.x, 6.x, or 7.x train. If
the you must perform certain tasks every hour or every day, you are unable to without the Scheduler feature.
the you must perform certain tasks every hour or every day, you are unable to without the Scheduler feature.