Cisco Cisco Nexus 5010 Switch Manuale Tecnico
Nexus 5500 Adapter−FEX Configuration Example
Document ID: 117691
Contributed by Charles Youssef, Cisco TAC Engineer.
Sep 04, 2014
Sep 04, 2014
Contents
Introduction
Prerequisites
Requirements
Components Used
Background Information
Adapter−FEX Overview
Configure
Ethernet vNICs Configuration
vHBAs Configuration
Verify
Troubleshoot
Virtual Ethernet Interface Does Not Come Up
Collect the Adapter Technical Support Information from the Server Side
Prerequisites
Requirements
Components Used
Background Information
Adapter−FEX Overview
Configure
Ethernet vNICs Configuration
vHBAs Configuration
Verify
Troubleshoot
Virtual Ethernet Interface Does Not Come Up
Collect the Adapter Technical Support Information from the Server Side
Introduction
This document describes how to configure, operate, and troubleshoot the Adapter−Fabric Extender (FEX)
feature on Nexus 5500 switches.
feature on Nexus 5500 switches.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these software and hardware versions:
Nexus 5548UP which runs Version 5.2(1)N1(4)
•
Unified Computing System (UCS) C−Series C210 M2 Rack Server with UCS P81E Virtual Interface
Card (VIC) that runs Firmware Version 1.4(2)
Card (VIC) that runs Firmware Version 1.4(2)
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command or packet capture setup.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command or packet capture setup.
Background Information