Cisco Cisco Nexus 5010 Switch Manuale Tecnico
Configuration of Jumbo MTU on Nexus 5000 and
7000 Series
7000 Series
Document ID: 112080
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Configurations
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configure
Configurations
Verify
Troubleshoot
Related Information
Introduction
This document discusses the issue which you may face when you configure a Jumbo Packet in a Nexus 5000
series switch. In this example, you test the packet size that is transfered between a Nexus 5000 and Nexus
7000 Switch with packet size other than 64 bytes (default) or a host that needs this requirement in the
network.
series switch. In this example, you test the packet size that is transfered between a Nexus 5000 and Nexus
7000 Switch with packet size other than 64 bytes (default) or a host that needs this requirement in the
network.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these series of Nexus Switches
Nexus 5020
•
NX-OS version 4.1(3)N2(1a)
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to the Cisco Technical Tips Conventions for more information on document conventions.
Configure
The packet loss can happen between two Nexus 5000 Switches or between a Nexus 5000 and Nexus 7000
Series switch.
Series switch.