Cisco Cisco Nexus 5010 Switch Guida Alla Progettazione

Page 96 of 119

Peer Gateway : Enabled

Dual-active excluded VLANs : -

Graceful Consistency Check : Enabled

vPC Peer-link status

---------------------------------------------------------------------

id Port Status Active vlans

-- ---- ------ --------------------------------------------------

1 Po10 up 1,3,10,50,60

You may also want to verify that the configurations of the two Cisco Nexus switches are consistent:

nexus5500-1# show vpc consistency-parameters global

Legend:

Type 1 : vPC will be suspended in case of mismatch

Name Type Local Value Peer Value

------------- ---- ---------------------- -----------------------

QoS 2 ([], [], [], [], [], ([], [], [], [], [],

[]) [])

Network QoS (MTU) 2 (1538, 0, 0, 0, 0, 0) (1538, 0, 0, 0, 0, 0)

Input Queuing (Bandwidth) 2 (100, 0, 0, 0, 0, 0) (100, 0, 0, 0, 0, 0)

Output Queuing (Bandwidth) 2 (100, 0, 0, 0, 0, 0) (100, 0, 0, 0, 0, 0)

STP Mode 1 MST MST

STP Disabled 1 None None

STP MST Region Name 1 dc1 dc1

STP MST Region Revision 1 3 3

STP MST Region Instance to 1

VLAN Mapping

STP Loopguard 1 Disabled Disabled

STP Bridge Assurance 1 Enabled Enabled

STP Port Type, Edge 1 Normal, Disabled, Normal, Disabled,

BPDUFilter, Edge BPDUGuard Disabled Disabled

STP MST Simulate PVST 1 Enabled Enabled

Allowed VLANs - 1,3,10,50,60 1,3,10,50,60

Local suspended VLANs - - -

The following command is useful after you define the vPC member ports, to check for orphan ports:

tc-nexus5k01# show vpc orphan-ports