Cisco Cisco Aironet 350 Access Points
11
Release Notes for Cisco Aironet 340 and 350 Series Access Points and 350 Series Bridges Running Firmware Version 12.02T1
OL-3868-01
Caveats
•
CSCdz48575—Default lost Ethernet action not appropriate.
See the
for a complete explanation of this
caveat.
•
CSCdz50218—Access point does not update home or foreign agent status when advertisement flags
change.
change.
When a local home or foreign agent is disabled on the router, the access point does not detect the
change from the the advertisement flags it receives. The access point continues to list the agent
addresses on the Statistics page.
change from the the advertisement flags it receives. The access point continues to list the agent
addresses on the Statistics page.
Workaround: Disable then enable proxy Mobile IP.
•
CSCdz58192—Root bridges with LEAP enabled on the native VLAN must have the security setting
matching that set on the Advanced Radio Setup page. If the settings do not match, the bridge link
will go down temporarily whenever an infrastructure device authenticates.
matching that set on the Advanced Radio Setup page. If the settings do not match, the bridge link
will go down temporarily whenever an infrastructure device authenticates.
•
CSCdy73695—When a repeater access point receives packets from a root access point while the
repeater is attempting to associate, the repeater sometimes displays this error:
repeater is attempting to associate, the repeater sometimes displays this error:
00:00:10 (Warning): Station <Root MAC address> Associated with Encryption, then
attempted to send an Unencrypted packet to <Repeater MAC address> (length 74)
The error occurs when WEP is not enabled on either the root or the repeater. When an association
response is received by the repeater, it no longer displays the error message and is able to
successfully pass data. However, if a significant amount of traffic, such as multicast traffic, is being
transmitted by the root access point while the repeater is attempting to associate, the repeater may
miss the association response from the root access point and never fully associate. In this case, the
root access point reports that the repeater is associated and the repeater reports that it is only
authenticated. The repeater continues to display warning messages about receiving unencrypted
packets and does not recover until it is rebooted.
response is received by the repeater, it no longer displays the error message and is able to
successfully pass data. However, if a significant amount of traffic, such as multicast traffic, is being
transmitted by the root access point while the repeater is attempting to associate, the repeater may
miss the association response from the root access point and never fully associate. In this case, the
root access point reports that the repeater is associated and the repeater reports that it is only
authenticated. The repeater continues to display warning messages about receiving unencrypted
packets and does not recover until it is rebooted.
•
CSCdy76093—Proxy Mobile IP with multiple authoritative access points continuously sends
update packets.
update packets.
See the
for details and procedures
to correct this problem.
•
CSCdx81372—Access point does not accept version 11.21-generated .ini file.
If you download the full configuration .ini from an access point running 11.21, upgrade to version
12.02T1, and then attempt to download the .ini file from an FTP server, the following error message
displays:
12.02T1, and then attempt to download the .ini file from an FTP server, the following error message
displays:
*** No Such MIB Variable as Specified on Initialization File Line xxx! for the
following variables:
awcAaaServerAccountingEnabled.x,
awcVoIPVlanId, awcVoIPVlanEnabled,
awcPublicVlanId.
*** Bad Value for MIB Variable awcVlanEncapMode Specified on Initialization File Line
xxx (error 13)!
Workaround—When producing .ini files, dump a non-default configuration for version 11.21
instead of a full configuration.
instead of a full configuration.