Cisco Cisco AMP Threat Grid 5004 Appliance Guida All'Installazione
Cisco AMP Threat Grid Appliance Administrator's Guide
CONFIGURATION MANAGEMENT
CONFIGURATION MANAGEMENT
15
CONFIGURATION MANAGEMENT
The initial Threat Grid Appliance configuration was performed during the appliance setup, as documented in the
Threat Grid Appliance Setup and Configuration Guide.
Threat Grid Appliance Setup and Configuration Guide.
Threat Grid Appliance configuration is managed in the TGSH Dialog and the OpAdmin Portal interfaces.
Threat Grid Organizations and User accounts are managed via the Threat Grid Portal UI (from the navigation bar
upper-right Welcome menu).
upper-right Welcome menu).
The TGSH Dialog and OpAdmin configuration tasks are described in detail in the following sections.
Network Interface Configuration Management – TGSH Dialog
The TGSH Dialog interface is used primarily to manage the following:
•
Network Interface Configuration
•
View the OpAdmin Administrator's Password
•
Install Updates
•
Enable Support Mode
•
Create and Submit Support Snapshots
Note:
If you are using DHCP to obtain your IPs, then skip to the Networking section below: Using DHCP.
1.
In the TGSH Dialog interface, select CONFIG_NETWORK.
The Network Configuration console opens, displaying the current network settings.
2.
Make your changes as needed.
Note:
You need to BACKSPACE over the old character before you can enter the new one.
3.
Leave the Dirty network DNS Name blank.
4.
After you finish updating the network settings, tab down and select Validate to validate your entries.
If invalid values have been entered, you may see errors. If this is the case, then fix the errors and re-
Validate.
Validate.
After validation, the Network Configuration Confirmation displays the values you've entered.
5.
Select Apply to apply your configuration settings.
The console will become a blank grey box, and then it will list detailed information about the configuration
changes that have been made.
changes that have been made.
6.
Select OK.
The Network Configuration Console refreshes again and displays the IP addresses you entered. Network
configuration is now complete.
configuration is now complete.
Reconnecting to the TGSH Dialog
TGSH Dialog will remain open on the console and can be accessed either by attaching a monitor to the
appliance or, if CIMC is configured, via remote KVM.
appliance or, if CIMC is configured, via remote KVM.