Cisco Cisco Packet Data Gateway (PDG)
Interchassis Session Recovery
Configuring Interchassis Session Recovery (ICSR) ▀
ASR 5500 System Administration Guide, StarOS Release 16 ▄
315
Configuring SRP Context for BGP for Destination Context
Use the following example to configure the BGP context and IP addresses in the SRP context.
configure
context <srp_ctxt_name>
service-redundancy-protocol
monitor bgp context <dest_ctxt_name> <neighbor_ip_address>
end
Setting Subscriber to Default Mode
Use the following example to set the subscriber mode to default.
configure
context <dest_ctxt_name>
subscriber default
end
Verifying BGP Configuration in Destination Context
Verify your BGP configuration by entering the show srp monitor bgp command (Exec Mode).
Disabling Bulk Statistics Collection on a Standby System
You can disable the collection of bulk statistics from a system when it is in the standby mode of operation.
Important:
When this feature is enabled and a system transitions to standby state, any pending accumulated
statistical data is transferred at the first opportunity. After that no additional statistics gathering takes place until the
system comes out of standby state.
system comes out of standby state.
Use the following example to disable the bulk statistics collection on a standby system.
configure
bulkstat mode
no gather-on-standby
end
Repeat this procedure for both systems.