Cisco Cisco Packet Data Gateway (PDG)

Pagina di 453
Engineering Rules   
▀  Context Rules 
 
 
▄  ASR 5000 System Administration Guide, StarOS Release 18 
388 
   
Context Rules 
 
A maximum of 63 contexts may be configured per chassis. 
 
Interfaces per Context 
 
512 Ethernet+PPP+tunnel interfaces 
 
32 ipv6ip tunnel interfaces 
 
511 GRE tunnels (2,048 GRE tunnels per chassis) 
 
256 loopback interfaces 
 
IP Addresses and IP Address Pools 
 
Up to 2,000 IPv4 address pools can be configured within a single context (regardless of the number of 
packet processing cards) with a total system limit of 5,000 IPv4 address pools for all contexts. 
 
Prior to Release 15.0: Up to 32 IPv6 pools can be configured within a single context. 
 
For Release 15.0 and higher: Up to 256 IPv6 pools can be configured within a single context. 
 
Each context supports up to 32,000,000 static IP pool addresses. You can configure a maximum total of 
96,000,000 static IP pool addresses per chassis. Each static IP pool can contain up to 500,000 
addresses. 
 
Each context supports up to 16,000,000 dynamic IP pool addresses. You can configure a maximum 
total of 32,000,000 dynamic IP pool addresses per chassis. Each dynamic IP pool can contain up to 
500,000 addresses. 
Important:
  The actual number of IP Pools supported per context and chassis depends on how 
many addresses are being used and how they are subnetted. 
 
Important:
  Each address in the pool requires approximately 60 bytes of memory. The amount of 
memory required, however, depends on a number of factors such as the pool type, and hold-timer 
usage. Therefore, in order to conserve available memory, you may need to limit the number of pools 
depending on the number of addresses to be configured and the number of installed application cards. 
 
The maximum number of simultaneous subscriber sessions is controlled by the installed capacity license for the 
service(s) supported. 
 
The maximum number of static address resolution protocol (ARP) entries per context is 128. 
 
The maximum number of domains per context is 2,048. 
 
ASN-GW services configured within the same context cannot communicate with each other. 
 
Routes 
 
Up to 1,200 static routes per context (48,000 per chassis). 
 
6,000 pool routes per context (6,000 per chassis) 
 
5,000 pool explicit host routes per context (6,000 per chassis) 
 
64 route maps per context 
 
BGP 
 
Releases 12 and 14: 16,000 BGP prefixes can be learned/advertised per context (64,000 per chassis)