Cisco Cisco Packet Data Gateway (PDG)
charge-volume
This command allows you to configure how the volume amount counter for eG-CDRs, UDRs, and DCCA
charging are calculated.
charging are calculated.
Product
All
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Charging Action Configuration
active-charging service service_name > charging-action charging_action_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-charging-action)#
Syntax Description
charge-volume { { dns | ftp-control | ftp-data | http | icmp | imap | ip | mms | pop3 | pptp | rtcp | rtp | rtsp
| sdp | secure-http | sip | smtp | tcp | tftp | udp | wsp | wtp } { bytes | packet-length | packets } [ downlink
| uplink ] | constant fixed_value }
| uplink ] | constant fixed_value }
{ default | no } charge-volume
default
Configures this command with its default setting.
Default: charge-volume ip bytes
no
If previously configured, deletes the charge-volume configuration in the current charging action.
{ dns | ftp-control | ftp-data | http | icmp | imap | ip | mms | pop3 | pptp | rtcp | rtp | rtsp | sdp | secure-http
| sip | smtp | tcp | tftp | udp | wsp | wtp }
| sip | smtp | tcp | tftp | udp | wsp | wtp }
Specifies the charge volume method for the specific rule definition.
• dns: Charge volume for DNS
• ftp-control: Charge volume for FTP-Control
• ftp-data: Charge volume for FTP-Data
• http: Charge volume for HTTP
• icmp: Charge volume for ICMP
Command Line Interface Reference, Modes A - B, StarOS Release 19
308
ACS Charging Action Configuration Mode Commands
charge-volume