Cisco Cisco Packet Data Gateway (PDG)
fw-and-nat action
This command allows you to create/configure/delete Firewall-and-NAT actions.
This command is available only in 11.0 and later releases. This command must be used to configure the
Stateful Firewall and NAT Action.
Stateful Firewall and NAT Action.
Important
Product
PSF
NAT
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration
active-charging service service_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-acs)#
Syntax Description
fw-and-nat action action_name [ -noconfirm ]
no fw-and-nat action action_name
no fw-and-nat action action_name
no
If previously configured, deletes the specified Firewall-and-NAT action from the active charging service.
action_name
Specifies the Firewall-and-NAT action to add/configure/delete.
action_name must be the name of a Firewall-and-NAT action, and must be an alphanumeric string of 1 through
63 characters. Each Firewall-and-NAT action must have a unique name.
63 characters. Each Firewall-and-NAT action must have a unique name.
-noconfirm
Specifies that the command must execute without prompting for confirmation.
Usage Guidelines
Use this command to create/configure/delete a Firewall-and-NAT action.
On entering this command, the CLI prompt changes to:
Command Line Interface Reference, Modes A - B, StarOS Release 19
417
ACS Configuration Mode Commands
fw-and-nat action