Cisco Cisco Packet Data Gateway (PDG)
firewall max-ip-packet-size
This command allows you to configure the maximum IP packet size (after IP reassembly) allowed over Stateful
Firewall.
Firewall.
In StarOS 8.0, this command is available in the ACS Configuration Mode. In StarOS 8.1 and StarOS 8.3,
use this command for Rulebase-based Firewall-and-NAT configuration. In StarOS 8.1 and StarOS 9.0
and later releases, for Policy-based Firewall-and-NAT configuration, this command is available in the
Firewall-and-NAT Policy Configuration Mode.
use this command for Rulebase-based Firewall-and-NAT configuration. In StarOS 8.1 and StarOS 9.0
and later releases, for Policy-based Firewall-and-NAT configuration, this command is available in the
Firewall-and-NAT Policy Configuration Mode.
Important
Product
PSF
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-rule-base)#
Syntax Description
firewall max-ip-packet-size packet_size protocol { icmp | non-icmp }
default firewall max-ip-packet-size protocol { icmp | non-icmp }
default firewall max-ip-packet-size protocol { icmp | non-icmp }
default
Configures the default maximum IP packet size configuration.
Default: 65535 bytes (for both ICMP and non-ICMP)
packet_size
Specifies the maximum packet size.
packet_size must be an integer from 30000 through 65535.
protocol { icmp | non-icmp }
Specifies the transport protocol:
• icmp: Configuration for ICMP protocol.
• non-icmp: Configuration for protocols other than ICMP.
Command Line Interface Reference, Modes A - B, StarOS Release 19
656
ACS Rulebase Configuration Mode Commands
firewall max-ip-packet-size