Cisco Cisco Packet Data Gateway (PDG)
post-processing priority
This command allows you to configure the post-processing priority and action to be taken on specific ruledef
in the current rulebase.
in the current rulebase.
Product
ACS
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-rule-base)#
Syntax Description
post-processing priority priority { group-of-ruledefs ruledefs_group_name | ruledef ruledef_name }
charging-action charging_action_name [ description description ]
no post-processing priority priority
charging-action charging_action_name [ description description ]
no post-processing priority priority
no
If previously configured, deletes the specified post-processing priority configuration from the current rulebase.
priority priority
Specifies priority for the ruledef/group-of-ruledefs in the current rulebase.
priority must be a unique value in the current rulebase, and must be an integer from 1 through 65535.
group-of-ruledefs ruledefs_group_name
Post-processing with group-of-ruledefs is not supported in this release.
Important
Specifies the group-of-ruledefs.
ruledefs_group_name must be the name of a group-of-ruledefs, and must be an alphanumeric string of 1
through 63 characters.
through 63 characters.
Command Line Interface Reference, Modes A - B, StarOS Release 19
704
ACS Rulebase Configuration Mode Commands
post-processing priority