Cisco Cisco Packet Data Gateway (PDG)
keepalive
This command configures various parameters for sending Keepalive messages to the remote end-point in
GRE tunnel interface configuration. By default sending keepalives is disabled.
GRE tunnel interface configuration. By default sending keepalives is disabled.
Product
All
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > Tunnel Interface Configuration > GRE Tunnel
Interface Configuration
Interface Configuration
configure > context context_name > interface interface_name tunnel > tunnel-mode gre
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-if-tunnel-mode)#
Syntax Description
keepalive [ interval time_interval num-retry retry ]
[ default | no ] keepalive
[ default | no ] keepalive
default
Sets the sending of Keepalives with default parameters.
interval: 10 seconds
num-retry: 3 retries
no
Disables the keepalive and turns off the sending of Keepalives messages.
interval time_interval
Default: 10
Specifies the time interval (in seconds) between two Keepalives sent to remote ends of GRE tunnel interface
configuration.
configuration.
time_interval must be an integer from 5 through 3600.
num-retry retry
Default: 3
Command Line Interface Reference, Modes G - H, StarOS Release 19
1029
GRE Tunnel Interface Configuration Mode Commands
keepalive