Cisco Cisco Packet Data Gateway (PDG)
s1u-relay
This command configures the S1-U Relay service for the HeNB-GW Access service. The user enters in the
S1-U Relay configuration mode using this command.
S1-U Relay configuration mode using this command.
Product
HeNB-GW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > HeNBGW-Access Service Configuration
configure > context context_name > henbgw-access-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-henbgw-access-service)#
Syntax Description
[ no ] s1u-relay
no
Removes the S1-U Relay service function from this HeNB-GW Access service configuration.
Usage Guidelines
Use this command to enable the S1-U Relay service function to the HeNB-GW Access Service. S1-U relay
service is disabled by default.
service is disabled by default.
Examples
Following command enables the S-U Relay service on a specific HeNB-GW Access service.
s1u-relay
s1u-relay
Command Line Interface Reference, Modes G - H, StarOS Release 19
1334
HeNB-GW Access Service Configuration Mode Commands
s1u-relay