Cisco Cisco Packet Data Gateway (PDG)
associate pgw-service
This command enables a previously configured P-GW service to which handover will be done by the GGSN
service. The P-GW service must be configured in Context Configuration mode before using this configuration.
service. The P-GW service must be configured in Context Configuration mode before using this configuration.
Product
GGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > GGSN Service Configuration
configure > context context_name > ggsn-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ggsn-service)#
Syntax Description
associate pgw-service svc_name
no associate pgw-service
no associate pgw-service
no
Removes the associated P-GW service from this GGSN service configuration.
svc_name
Identifies the name of the P-GW service preconfigured in Context Configuration mode to which handover
will be done.
will be done.
The svc_name must be an alphanumeric string from 1 through 63 characters.
Usage Guidelines
Use this command to allow enabling/disabling bearer handover from GGSN to a P-GW service. The service
defined for P-GW can be configured in Context configuration mode.
defined for P-GW can be configured in Context configuration mode.
The P-GW's eGTP service should have the same bind address as GGSN service and P-GW and GGSN should
share same GTP-U, otherwise handover will fail.
share same GTP-U, otherwise handover will fail.
Examples
Following command enables P-GW service named pgw-test handover with specific GGSN service.
associate pgw-service pgw-test
associate pgw-service pgw-test
Command Line Interface Reference, Modes G - H, StarOS Release 19
6
GGSN Service Configuration Mode Commands
associate pgw-service