Cisco Cisco Packet Data Gateway (PDG)
threshold aaa-auth-failure
Configures authentication failure, alarm or alert thresholds for the system.
Product
PDSN
GGSN
HA
ASN-GW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
threshold aaa-auth-failure high_thresh [ clear low_thresh ]
default threshold aaa-auth-failure
default threshold aaa-auth-failure
high_thresh
Default: 0
Specifies the high threshold number of authentication failures that must be met or exceeded within the polling
interval to generate an alert or alarm.high_thresh is an integer from 0 through 10000000. A value of 0 disables
the threshold.
interval to generate an alert or alarm.high_thresh is an integer from 0 through 10000000. A value of 0 disables
the threshold.
clear low_thresh
Default: 0
Specifies the low threshold number of authentication failures that maintains a previously generated alarm
condition. If the number of failures falls beneath the low threshold within the polling interval, a clear alarm
will be generated. low_thresh is an integer from 0 through 10000000. A value of 0 disables the threshold.
condition. If the number of failures falls beneath the low threshold within the polling interval, a clear alarm
will be generated. low_thresh is an integer from 0 through 10000000. A value of 0 disables the threshold.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Command Line Interface Reference, Modes G - H, StarOS Release 19
441
Global Configuration Mode Commands (T-threshold phspc)
threshold aaa-auth-failure