Cisco Cisco Packet Data Gateway (PDG)
threshold subscriber active
Configures alarm or alert thresholds for the number of active subscribers in the system.
Product
PDSN
GGSN
SGSN
HA
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
threshold subscriber active high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of active subscriber sessions facilitated by the system that must be met
or exceeded within the polling interval to generate an alert or alarm.
or exceeded within the polling interval to generate an alert or alarm.
high_thresh is an integer from 0 through 4000000. A value of 0 disables the threshold.
clear low_thresh
Default: 0
Specifies the low threshold number of active subscriber sessions facilitated by the system that maintains a
previously generated alarm condition. If the number of sessions falls beneath the low threshold within the
polling interval, a clear alarm will be generated.
previously generated alarm condition. If the number of sessions falls beneath the low threshold within the
polling interval, a clear alarm will be generated.
low_thresh is an integer from 0 and 4000000. A value of 0 disables the threshold.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Command Line Interface Reference, Modes G - H, StarOS Release 19
910
Global Configuration Mode Commands (threshold ppp - url-blacklisting)
threshold subscriber active