Cisco Cisco Packet Data Gateway (PDG)
gtpc decode-as-hex
This command configures the GGSN to decode the MCC-MNC parameters from the User Location Information
(ULI) to hexadecimal digits.
(ULI) to hexadecimal digits.
Product
GGSN
Privilege
Administrator, Config Administrator
Command Modes
Exec > Global Configuration > Context Configuration > GGSN Service Configuration
configure > context context_name > ggsn-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ggsn-service)#
Syntax Description
[ default | no ] gtpc decode-as-hex
default
This CLI is disabled by default. The received MCC-MNC parameters of ULI are decoded assuming that, it
contains decimal digits only.
contains decimal digits only.
no
Removes the default configuration .
Usage Guidelines
The GTP parameter ULI contains encoded MCC-MNC digits. This new CLI configures GGSN to decode this
MCC-MNC into hexadecimal digits. When CLI is disabled, current behavior is in effect - The received
MCC-MNC is decoded assuming that, it contains decimal digits only.
MCC-MNC into hexadecimal digits. When CLI is disabled, current behavior is in effect - The received
MCC-MNC is decoded assuming that, it contains decimal digits only.
When CLI is enabled and if the received MCC-MNC is valid, it is decoded into decimal digits. If the received
MCC-MNC is invalid, all digits are decoded into hexadecimal digits, including filler digits, if any. Hexadecimal
digits are represented using Upper Case ASCII characters (A, B, C, D, E, F).
MCC-MNC is invalid, all digits are decoded into hexadecimal digits, including filler digits, if any. Hexadecimal
digits are represented using Upper Case ASCII characters (A, B, C, D, E, F).
Examples
The following command decodes MCC-MNC as hexadecimal:
gtpc decode-as-hex
gtpc decode-as-hex
Command Line Interface Reference, Modes G - H, StarOS Release 19
29
GGSN Service Configuration Mode Commands
gtpc decode-as-hex