Cisco Cisco Packet Data Gateway (PDG)
diameter result-code
This command enables sending a GTP Create-PDP-Context-Rsp message with cause code based on the DCCA
result code.
result code.
Product
All
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Credit Control Configuration
active-charging service service_name > credit-control
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-dcca)#
Syntax Description
diameter result-code { authorization-rejected | credit-limit-reached | end-user-service-denied |
user-unknown } use-gtp-cause-code { apn-access-denied-no-subscription | authentication-failure |
no-resource-available | system-failure }
default diameter result-code { authorization-rejected | credit-limit-reached | end-user-service-denied |
user-unknown } use-gtp-cause-code { apn-access-denied-no-subscription | authentication-failure |
no-resource-available | system-failure }
default diameter result-code { authorization-rejected | credit-limit-reached | end-user-service-denied |
user-unknown } use-gtp-cause-code
default
Configures this command with the default setting.
In 12.1 and earlier releases: no-resource-available
In 12.2 and later releases: system-failure
authorization-rejected
Result code received as DIAMETER_AUTHORIZATION_REJECTED(5003).
credit-limit-reached
Result code received as DIAMETER_CREDIT_LIMIT_REACHED(4012).
end-user-service-denied
Result code received as DIAMETER_END_USER_DENIED(4010).
user-unknown
Result code received as DIAMETER_USER_UNKNOWN(5030).
Command Line Interface Reference, Modes C - D, StarOS Release 19
1029
Credit Control Configuration Mode Commands
diameter result-code