Cisco Cisco Packet Data Gateway (PDG)
Use this command to configure the cause code returned to a UE when the context received from a peer SGSN
(during a TAU procedure) does not contain any active PDP contexts. By default, the MME sends the UE the
#40 - No PDP context activated cause code when encountering this condition.
(during a TAU procedure) does not contain any active PDP contexts. By default, the MME sends the UE the
#40 - No PDP context activated cause code when encountering this condition.
If a cause code mapping is specified in both the call-control-profile associated with a call, and also the
mme-service, the cause configured for the call-control-profile will be signalled to the UE. See also the
local-cause-code-mapping command in the mme-service configuration mode. This command is described
in the MME Service Configuration Mode Commands chapter.
mme-service, the cause configured for the call-control-profile will be signalled to the UE. See also the
local-cause-code-mapping command in the mme-service configuration mode. This command is described
in the MME Service Configuration Mode Commands chapter.
Examples
The following command maps the "plmn-not-allowed" cause code to the no active bearer condition:
local-cause-code-mapping no-active-bearers emm-cause-code plmn-not-allowed
Command Line Interface Reference, Modes C - D, StarOS Release 19
137
Call Control Profile Configuration Mode
local-cause-code-mapping no-active-bearers