Cisco Cisco Packet Data Gateway (PDG)
response-timeout
This command configures the Response Timeout parameter. Response timeout specifies the maximum allowed
response time for request messages sent from Diameter applications to Diameter server. On failure of reception
of response for those request message within this specified time, this will be handled as failure by the
corresponding applications and appropriate failure action will be initiated.
response time for request messages sent from Diameter applications to Diameter server. On failure of reception
of response for those request message within this specified time, this will be handled as failure by the
corresponding applications and appropriate failure action will be initiated.
Product
All
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > Diameter Endpoint Configuration
configure > context context_name > diameter endpoint endpoint_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ctx-diameter)#
Syntax Description
response-timeout timeout
default response-timeout
default response-timeout
default
Configures this command with the default setting.
Default: 60 seconds
timeout
Specifies the response timeout duration in seconds, and the value must be an integer from 1 through 300.
Usage Guidelines
Use this command to configure the Response Timeout parameter.
Examples
The following command sets the response timeout to 100 seconds:
response-timeout 100
response-timeout 100
Command Line Interface Reference, Modes C - D, StarOS Release 19
1847
Diameter Endpoint Configuration Mode Commands
response-timeout