Cisco Cisco Packet Data Gateway (PDG)
Call Control Profile Configuration Mode
The MME and SGSN each support a maximum of 1,000 call control profiles; only one profile can be
associated with an operator policy.
associated with an operator policy.
By configuring a call control profile, the operator fine tunes any desired restrictions or limitations needed
to control call handling per subscriber or for a group of callers across IMSI (International Mobile Subscriber
Identity) ranges.
to control call handling per subscriber or for a group of callers across IMSI (International Mobile Subscriber
Identity) ranges.
Call Control Profile configuration mode defines call-handling rules which can be combined with other
profiles – such as an APN profile (see the APN Profile Configuration Mode Commands chapter) – when
using the Operator Policy feature. The call control profile is a key element in the Operator Policy feature
and the profile is not valid until it is associated with an operator policy (see the associate command in the
Operator Policy Configuration Mode Commands chapter).
profiles – such as an APN profile (see the APN Profile Configuration Mode Commands chapter) – when
using the Operator Policy feature. The call control profile is a key element in the Operator Policy feature
and the profile is not valid until it is associated with an operator policy (see the associate command in the
Operator Policy Configuration Mode Commands chapter).
Command Modes
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-call-control-profile-
profile_name
)#
The commands or keywords/variables that are available are dependent on platform type, product version,
and installed license(s).
and installed license(s).
Important
•
•
•
•
•
•
•
•
Command Line Interface Reference, Modes C - D, StarOS Release 19
1