Cisco Cisco Packet Data Gateway (PDG)
radius probe-timeout
This command configures the timeout duration to wait for a response for RADIUS authentication probes.
Product
All products supporting Interchassis Session Recovery (ICSR)
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ctx)#
Syntax Description
radius probe-timeout timeout_duration
default radius probe-timeout
default radius probe-timeout
default
Configures the default setting.
Default: 3
timeout_duration
Specifies the time duration (in seconds) to wait for a response from the RADIUS server before resending the
authentication probe. timeout_duration must bean integer from 1 through 65535. Default: 3
authentication probe. timeout_duration must bean integer from 1 through 65535. Default: 3
Usage Guidelines
Use this command for ICSR support to set the duration to wait for a response before re-sending the RADIUS
authentication probe to the RADIUS server.
authentication probe to the RADIUS server.
Examples
The following command sets the authentication probe timeout to 120 seconds:
radius probe-timeout 120
Command Line Interface Reference, Modes C - D, StarOS Release 19
921
Context Configuration Mode Commands N-R
radius probe-timeout