Cisco Cisco Packet Data Gateway (PDG)
diameter origin end-point
This command binds/associates a pre-configured Diameter host/realm (PCEF/BBERF) over Gx/Gxa interface
with a PCC-Policy-Service to be used for subscriber service control and policy profile management.
with a PCC-Policy-Service to be used for subscriber service control and policy profile management.
Product
IPCF
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > PCC Policy Service Configuration
configure > context context_name > pcc-policy-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-pccpolicy-service)#
Syntax Description
diameter origin endpoint dia_endpoint_name
no diameter origin endpoint
no diameter origin endpoint
no
Removes the associated Diameter Origin Endpoint configuration from PCC-Policy-Service instance configured
for IPCF configuration.
for IPCF configuration.
any
Sets the PCC-Policy-Service instance to use any available PCEF/BBERF node for policy interfaces (Gx/Gx-like)
support.
support.
dia_endpoint_name
The dia_endpoint_name is a predefined Diameter origin endpoint node and must be an alphanumerical string
from 1 through 63 characters.
from 1 through 63 characters.
Usage Guidelines
Use this command to bind the PCEF/BBERF node over Gx/Gx-like interface by associating a pre-configured
Diameter Origin Endpoint with a PCC-Policy-Service.
Diameter Origin Endpoint with a PCC-Policy-Service.
The Diameter origin endpoint must be a pre-configured instance in the Context Configuration Mode. For
more information on Diameter origin endpoint configuration, refer Diameter Endpoint Configuration Mode
Commands chapter.
more information on Diameter origin endpoint configuration, refer Diameter Endpoint Configuration Mode
Commands chapter.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
1376
PCC-Policy-Service Configuration Mode Commands
diameter origin end-point