Cisco Cisco Packet Data Gateway (PDG)
custom-reauth-trigger
This command enables custom reauthorization event triggers.
Product
All
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > IMS Authorization Configuration > Policy Control
Configuration
Configuration
configure > context context_name > ims-auth-service service_name > policy-control
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-imsa-dpca)#
Syntax Description
custom-reauth-trigger { apn-ambr-mod-failure | default-bearer-qos-change |
default-bearer-qos-mod-failure | qos-change | resource-modification-request | ue-ip-addr-allocate |
ue-ip-addr-release | none | { preservation-changed | reactivation-changed } + }
default custom-reauth-trigger
default-bearer-qos-mod-failure | qos-change | resource-modification-request | ue-ip-addr-allocate |
ue-ip-addr-release | none | { preservation-changed | reactivation-changed } + }
default custom-reauth-trigger
default
Configures the default setting for this command. The default setting is to enable all the event triggers.
none
Disables all custom event triggers.
apn-ambr-mod-failure
Enables APN AMBR Modification Failure event trigger.
default-bearer-qos-change
Enables Default EPS bearer QoS change event trigger.
default-bearer-qos-mod-failure
Enables Default EPS Bearer QOS Modification Failure event trigger.
qos-change
Enables QoS change trigger.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
1694
Policy Control Configuration Mode Commands
custom-reauth-trigger