Cisco Cisco Packet Data Gateway (PDG)
IPSP Configuration Mode Commands
For information on configuring and using IPSP refer to the System Administration Guide.
Important
The IPSP Configuration Mode is used to configure properties for the IP Pool Sharing Protocol (IPSP).
System-based HA services use IPSP during an offline-software upgrade to avoid the assignment of duplicate
IP addresses to sessions while allowing them to maintain the same address, and to preserve network capacity
System-based HA services use IPSP during an offline-software upgrade to avoid the assignment of duplicate
IP addresses to sessions while allowing them to maintain the same address, and to preserve network capacity
Command Modes
Exec > Global Configuration > Context Configuration > Ethernet Interface Configuration > IP Pool Sharing
Protocol Configuration
Protocol Configuration
configure > context context_name > interface interface_name broadcast > pool-share-protocol { primary
ip_address | secondary ip_address }
ip_address | secondary ip_address }
The commands or keywords/variables that are available are dependent on platform type, product version,
and installed license(s).
and installed license(s).
Important
•
•
•
•
Command Line Interface Reference, Modes I - Q, StarOS Release 19
153