Cisco Cisco Packet Data Gateway (PDG)
access-protocol
This command configures the access protocol parameters for the IuPS service.
Product
SGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > IuPS Service Configuration
configure > context context_name > iups-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ctx-iups-service)#
Syntax Description
access-protocol sccp-network sccp_net_id
no access-protocol sccp-network
no access-protocol sccp-network
no
Removes a previously configured access protocol value.
sccp-network sccp_net_id
Specifies the Signaling Connection Control Part (SCCP) for this IuPS service to use.
sccp_net_id must be an integer from 1 to 16.
Usage Guidelines
Use this command to configure access protocol parameters for the current IuPS service.
Examples
The following command specifies that the current Iu-PS service should use SCCP 1:
access-protocol sccp-network 1
access-protocol sccp-network 1
Command Line Interface Reference, Modes I - Q, StarOS Release 19
327
IuPS Service Configuration Mode Commands
access-protocol