Cisco Cisco Packet Data Gateway (PDG)
show logical-port utilization table
Displays logical port (VLAN and NPU) utilization for a specified interface port.
Product
All
Privilege
Security Administrator, Administrator, Operator, Inspector
Command Modes
Exec
The following prompt is displayed in the Exec mode:
[local]
host_name
#
Syntax Description
show logical port utilization table slot/port [vlan { 5-minute | hourly }] [ | { grep grep_options | more }
]
]
slot/port
Specifies the port for which logical-port statistics will be displayed. The slot and port must refer to an installed
card and port.
card and port.
vlan { 5-minute | hourly }
Displays only active VLAN information for the specified collection interval.
• 5-minute: Displays 5-minute utilization intervals for the past 24 hours.
• hourly: Displays hourly utilization intervals for the past 24 hours.
| { grep grep_options | more }
Pipes (sends) the output of this command to the specified command. You must specify a command to which
the output of this command will be sent.
the output of this command will be sent.
For details on the usage of grep and more, refer to the Regulating a Command's Output section of the Command
Line Interface Overview chapter.
Line Interface Overview chapter.
Usage Guidelines
View logical port (VLAN) statistics for 5-minute intervals on port 17/1.
Examples
show logical-port utilization table 17/1 vlan 5-minute
Command Line Interface Reference, Modes E - F, StarOS Release 19
1270
Exec Mode show Commands (H-L)
show logical-port utilization table