Cisco Cisco Packet Data Gateway (PDG)
threshold reg-reply-error
Set an alarm or alert based on the number of registration reply errors per FA service.
Product
PDSN
ASN-GW
GGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > FA Service Configuration
configure > context context_name > fa-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-fa-service)#
Syntax Description
threshold reg-reply-error high_thresh [ clear low_thresh ]
no threshold reg-reply-error
no threshold reg-reply-error
no
Deletes the alert or alarm.
high_thresh
Default: 0
The high threshold number of registration reply errors that must be met or exceeded within the polling interval
to generate an alert or alarm. high_thresh can be an integer from 0 through 100000.
to generate an alert or alarm. high_thresh can be an integer from 0 through 100000.
You must enter a value between 1 and 100000 to trigger an alert/alarm.
Important
clear low_thresh
Default:0
The low threshold number of registration reply errors that must be met or exceeded within the polling interval
to clear an alert or alarm. low_thresh can be an integer from 0 through 100000.
to clear an alert or alarm. low_thresh can be an integer from 0 through 100000.
Command Line Interface Reference, Modes E - F, StarOS Release 19
1647
FA Service Configuration Mode Commands
threshold reg-reply-error