Cisco Cisco Packet Data Gateway (PDG)
Firewall-and-NAT Policy Configuration Mode
Commands
Commands
The Firewall-and-NAT Policy Configuration Mode enables configuring Stateful Firewall (FW) and Network
Address Translation (NAT) policies.
Address Translation (NAT) policies.
Command Modes
Exec > ACS Configuration > Firewall-and-NAT Policy Configuration
active-charging service service_name > fw-and-nat policy policy_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-fw-and-nat-policy)#
This configuration mode is only available in 8.1, 9.0, and later releases. This configuration mode must be
used to configure Policy-based Stateful Firewall and NAT features.
used to configure Policy-based Stateful Firewall and NAT features.
Important
The commands or keywords/variables that are available are dependent on platform type, product version,
and installed license(s).
and installed license(s).
Important
•
•
•
•
•
•
•
•
•
Command Line Interface Reference, Modes E - F, StarOS Release 19
1675