Cisco Cisco Packet Data Gateway (PDG)
nat check-point-info
This command enables or disables the checkpointing of basic NAT, H323 and SIP ALG recovery. ICSR
recovery can also be enabled or disabled for basic NAT and SIP flows.
recovery can also be enabled or disabled for basic NAT and SIP flows.
Product
PSF
NAT
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Firewall-and-NAT Policy Configuration
active-charging service service_name > fw-and-nat policy policy_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-fw-and-nat-policy)#
Syntax Description
[ default | no ] nat check-point-info { basic [ icsr-also | limit-flows limit ] | h323-alg | sip-alg [ icsr-also ]
}
default
Configures this command with its default setting.
Default: Disabled
no
Disables the basic NAT recovery and stand-alone H323 ALG and SIP ALG recovery. Also disables ICSR
recovery for SIP ALG.
recovery for SIP ALG.
basic [ icsr-also | limit-flows limit ]
Configures the basic flow checkpointing information.
• icsr-also: Enables checkpointing for ICSR.
• limit-flows: Limits the specified flows for basic NAT checkpointing. limit must be an integer from 1
through 100.
Default: 100
Command Line Interface Reference, Modes E - F, StarOS Release 19
1719
Firewall-and-NAT Policy Configuration Mode Commands
nat check-point-info