Cisco Cisco Packet Data Gateway (PDG)
[ from card_num | to card_num ]
Copies files from a source card to a destination card specified by slot numbers.
-noconfirm
Executes the command without displaying "are you sure" prompts.
Usage Guidelines
Synchronize the file systems between active and standby storage devices.
Examples
The following command all file systems on system management cards:
filesystem synchronize al1
filesystem synchronize al1
The following command sequence appears when filesystem synchronize /flash is run after save configuration
/flash/filename -redundant is executed and a change has been made to the configuration:
filesystem synchronize /flash
2 to be updated on card 2
/flash/filename -redundant is executed and a change has been made to the configuration:
filesystem synchronize /flash
2 to be updated on card 2
/flash/oam.cfg
/flash/service.cfg
/flash/service.cfg
0 to be updated (but are newer) on card 2
0 to be deleted on card 2
Are you sure? [Yes|No]:
0 to be deleted on card 2
Are you sure? [Yes|No]:
You must confirm the synchronization before it will be initiated.
If "No files to update" appears, you are returned to the CLI prompt.
Command Line Interface Reference, Modes E - F, StarOS Release 19
543
Exec Mode Commands (D-S)
filesystem synchronize