Cisco Cisco ASR 5000
APN Configuration Mode Commands
▀ accounting-mode
▄ Command Line Interface Reference, StarOS Release 18
1292
context. As specified by the standards, a CDR is not generated when a session starts - CDRs are generated
according to the interim triggers (configured using the cc command in the GGSN service configuration mode)
and a CDR is generated when the session ends. For interim accounting, STOP/START pairs are sent based on
configured triggers.
GTPP version 2 is always used. However, if version 2 is not supported by the CGF, the system reverts to
using GTPP version 1. All subsequent CDRs are always fully-qualified partial CDRs. All CDR fields are R4.
If the
according to the interim triggers (configured using the cc command in the GGSN service configuration mode)
and a CDR is generated when the session ends. For interim accounting, STOP/START pairs are sent based on
configured triggers.
GTPP version 2 is always used. However, if version 2 is not supported by the CGF, the system reverts to
using GTPP version 1. All subsequent CDRs are always fully-qualified partial CDRs. All CDR fields are R4.
If the
radius
option is used, RADIUS protocol is used as configured in the Context Configuration mode or
the AAA Server Group Configuration mode.
If the RADIUS protocol is used, accounting messages can be sent over a AAA interface or the Gi to the
RADIUS server. The AAA or Gi interface(s) and RADIUS functionality are typically configured with the
system’s destination context along with the APN. RADIUS accounting begins immediately after an IP
address is allocated for the MS. Interim accounting can be configured using the
If the RADIUS protocol is used, accounting messages can be sent over a AAA interface or the Gi to the
RADIUS server. The AAA or Gi interface(s) and RADIUS functionality are typically configured with the
system’s destination context along with the APN. RADIUS accounting begins immediately after an IP
address is allocated for the MS. Interim accounting can be configured using the
radius accounting
interim interval
. The
radius accounting interim interval
command sends INTERIM-
UPDATE messages at specific intervals.
Keywords to this command can be used in combination to each other, depending on configuration
requirements.
Keywords to this command can be used in combination to each other, depending on configuration
requirements.
Important:
If the accounting type in the APN is set to ‘none’ then G-CDRs will not be generated. If accounting
type is left as default “GTPP” and “billing-records” are configured in the ACS Rulebase Configuration Mode, then both
G-CDRs and eG-CDRs would be generated.
G-CDRs and eG-CDRs would be generated.
Example
The following command configures the APN to use the RADIUSr protocol for accounting:
accounting-mode radius
accounting-mode radius no-interims no-early-pdus
accounting-mode radius no-early-pdus no-interims